To setup Mach3 on the Config menu select Ports and Pins.

Next Un select Max CL Mode enabled so as to allow the port #1 settings to work.

Set Port #1 enabled and Kernel Speed at 35000Hz.

Press Apply.

Next select Motor Outputs. Set as shown.

Next set Output Signals as shown.

Next select Motor Tuning.

Select X-Axis button and enter 502 under Steps ,600 under velocity, and 35 for Acceleration.

Select Y-Axis button and enter 502 under Steps ,600 under velocity, and 35 for Acceleration.

Select Z-Axis button and enter 26770.82353 under Steps ,10 under velocity, and 5 for Acceleration.

Next select Save Setting under Config Menu.